Napa Carlyle TW14TD Instruction Manual page 5

REPLACING THE HEAD KIT (CONT.)
Step 5: Insert the switch into the square hole on the pawl
making sure the the tail of the switch and the bottom of the
pawl (See Fig. 5) are both pointing in the same direction.
Then fasten with the switch screw.
Step 6: Insert the driver into the ratchet head aligning the
teeth on the driver with the teeth on the pawl. See Fig. 6
Step 7: Place the lid on the driver with the chamfer side
of the lid facing out. See Fig. 7
TW14TD, TW38TD2
Fig. 5
Fig. 6
Fig. 7
5 Rev. 02/27/15