Power; Bypass; Input (Left/Mono & Right); Output (Left & Right) - Alesis NanoVerb Stereo Amplifier Reference Manual

Chapter 4 – Description of Controls
This is a plug for connecting the Alesis Model P3 9VAC power supply (supplied). The
power supply included with the NanoVerb is compatible with the electrical
requirements of the country of purchase, and should be connected to the proper
electrical outlet. (In the USA, this is 120VAC.) The correct power supply must be
used AT ALL TIMES. Any other power supply might create a fire risk and/or
permanently damage your unit. This damage would NOT be covered under your
warranty.

Bypass

This is a 1/4" phone jack which connects to a momentary (not latching) footswitch,
either normally-open or normally-closed. When the Footswitch is pressed, the
NanoVerb will stop producing effects and only the dry signal will pass through the
unit. If the Footswitch is pressed again, effects output will continue.
Input (Left/Mono & Right)
These are 1/4" unbalanced phone jacks which connect to sources such as the effects
sends of mixing consoles. They may be used with nominal input levels from -20dBV
(guitar level) to +4dBu. For mono applications, use the [LEFT/MONO] input.
The [LEFT/MONO] input jack is normalled to the [RIGHT] jack. This means that when
nothing is plugged into the [RIGHT] input jack, the signal present at the
[LEFT/MONO] input is routed to the [RIGHT] as well.
Output (Left & Right)
These are 1/4" unbalanced phone jacks which connect to devices such as the effects
returns on a mixing console or power amplifier inputs. For mono applications, use the
[LEFT] output.
26 NanoVerb Reference Manual