Table of Contents
Advertisement
SCSI BIOS messages
SCSI BIOS messages
The following messages can appear during system startup if you have enabled the SCSI
BIOS:
Device connected, but not ready
The SCSI device connected to the ultra-wide SCSI controller does not react to
commands from the SCSI controller. Set
for the SCSI device concerned. If the message still appears, check the settings
required for the SCSI device in its documentation.
Start unit request failed
The SCSI BIOS could not issue a start unit command to the SCSI device. Call the
and set
SCSI Setup
Time-out failure during ...
A timeout has occurred. Check the SCSI bus termination. Remove the SCSI cable
from the ultra-wide SCSI controller and restart the system. If system startup is
successful, check the SCSI cable. One of the SCSI devices may be defective. Check
the SCSI devices.
26 - English
to
Send Start Unit
No
Send Start Unit Command
for the SCSI device concerned.
to
in the
Yes
SCSI Setup
A26361-D992-Z121-2-7419
Advertisement
Table of Contents
