Siemens D992 Technical Manual page 21

Removing the Pentium II
If the Pentium II has a temperature sensor, pull out the associated cable.
Ê
Press the clamps (2) on either side of the Pentium II inwards and pull the Pentium II
Ê
up and out.
Insert the terminating board into the slot if necessary.
Ê
Installing the Pentium II
Remove the terminating board if necessary.
Ê
Place the Pentium II in the holder (B).
Ê
Push the Pentium II down in the holder and press it into the slot until the clamps (A)
Ê
to the left and right snap into place.
Set the clock frequency of the new Pentium II using switches 5 to 8 of the switch
Ê
block.
If the Pentium II has a temperature sensor, attach the associated cable to the
Ê
connector for the temperature sensor on the system board.
A26361-D992-Z121-2-7419
2 2
Extensions: D992 mono
2
1
English - 13