Table of Contents
Advertisement
SCSI Disk Utilities
When you select the
connected to the SCSI bus. You are also offered two menus for hard disk drives:
and
.
Format Disk
Verify
With
you can have a selected hard disk drive checked. All defects that are detected
Verify
will be entered in the existing error list for the hard disk.
Format Disk
With
a selected hard disk is formatted in low-level format. Normally hard
Format Disk
disks are already formatted in low-level format. You should use this menu item only if
you want to erase the hard disk completely and regenerate the error list.
Eliminating errors on the SCSI controller
Most problems with the onboard ultra-wide SCSI controller occur when SCSI devices
are prepared (e.g. termination) and connected to the SCSI bus. Check the following
points if you have problems with the ultra-wide SCSI controller or the connected SCSI
devices:
•
Are all SCSI devices supplied with power?
•
Are the SCSI and power cables connected correctly on the SCSI device?
•
Is the SCSI cable connected correctly to the system board?
•
Has each SCSI device and the onboard SCSI controller been set to a different SCSI
ID?
•
Are the SCSI devices and the onboard SCSI controller correctly terminated?
•
Is the SCSI controller activated in the system BIOS (
•
Is parity checking either enabled or disabled on all SCSI devices on the SCSI bus?
A26361-D992-Z121-2-7419
menu item, you are shown a list of all the devices
SCSI Disk Utilities
SCSI Disk Utilities
)?
BIOS Setup
Verify
English - 25
Advertisement
Table of Contents
