Table of Contents
Advertisement
G O B O I N S TA L L AT I O N
REPLACING A ROTATING GOBO
Place the Elation Proteus Excalibur fixture on a firm flat surface. Locate the (10x) screws on
the side of the moving head and remove them. With the panel set aside, locate the Pattern
Bracket Assembly and remove the (4x) screws that secure it to the internal housing frame.
Locate the specific Rotating Gobo to replace. Carefully grip the Gobo using your thumb and index
finger, gently lift it slightly, and then pull it out and away until it fully clears the Gobo Wheel.
Locate the tab of the spring, and with a precision pick (or similar tool), carefully press the
retaining spring inward to relieve the tension. Remove the retaining spring and carefully
separate the GOBO from the GOBO Holder. Lastly, remove the flat washer attached to the
removed GOBO and attach it to the desired replacement GOBO. Install the replacemet Rotating
GOBO following the steps above in reverse order.
CAUTION: TAKE CARE NOT TO SCRATCH GOBO OR GOBO HOLDER
16
Advertisement
Table of Contents
