Refrigerator Removal - Dometic RM2620 Installation And Operating Instructions Manual

Electrical connection
120 V AC connection
The refrigerator is equipped with a grounded three-prong plug
for your protection against shock hazards. It should be plugged
directly into a properly grounded three-prong receptacle. Do
not cut or remove the grounding prong from this plug!
The free length of the cord is 2 feet and therefore recommended
that the receptacle be located to the left side (opposite side of
refrigerator burner assembly) of the refrigerator (viewed from
the rear). The receptacle should be 3" (from the bottom of the
plastic receptacle) above the refrigerator mounting floor. This
allows easy access through the vent door. The cord should be
routed to avoid direct contact with the burner cover, flue cover
or any other components that could damage the cord insulation.
120 Volt AC
receptacle
3"
Before removing the refrigerator:
• Verify that the AC and DC voltage leads are disconnected.
• Shut off the gas supply.
• Disconnect the gas supply line at the rear of the refrigerator.
Always use a back up wrench when loosening and tighten-
ing connections.
INSTALLATION INSTRUCTIONS

REFRIGERATOR REMOVAL

12 V DC connection
This refrigerator model is not designed for 12 V DC operation
of the cooling system; however, a continuous 12 V DC must be
supplied to the refrigerator to operate the controls.
Use a minimum of a 14 gauge wire between the battery and
refrigerator to supply the control voltage. The connection is
made to the positive (+) and negative (-) terminals located at
the rear of the refrigerator. Correct polarity must be observed
when connecting to the DC supply.
NOTE! Do not use the chassis or vehicle frame as one of the
conductors. Connect two wires at the refrigerator and route to
the DC supply.
To remove the refrigerator, follow these steps:
1. Cap the gas supply line.
2. Loosen the screws anchoring the refrigerator to the
enclosure.
3. Slide the refrigerator out of the compartment.
When replacing the refrigerator make sure that the sealing
strips are properly positioned. Check all connections for gas
leaks. Replacement is the reverse of removal.
- 8 -