Range; Accessories; Compliance; Machine Identification - Trane LIFT 162-P-1204-P Installation Operation & Maintenance

1.2.1 Symbols
• This publication contains the following symbols:
Draws attention to actions that can cause serious injury if not performed
Danger
correctly.
Prohibited Draws attention to actions that impose a prohibition.

1.3 Range

LIFT
1.3.1 Available versions
LIFT Heat Pump

1.4 Accessories

Factory fitted accessories
IM Automatic circuit breakers
SL Low noise version
RFM Cooling circuit shut-off valve on discharge line
RFL Cooling circuit shut-off valve on liquid line
PV3E 3-Way electronic pressostatic valve for evaporation control
PV3C 3-Way electronic pressostatic valve for cold start
SS Soft start
IS Modbus RTU protocol, RS485 serial interface
IST Modbus TCP/IP protocol, Ethernet port
ISB BACnet MSTP protocol, RS485 serial interface
ISBT BACnet TCP/IP protocol, Ethernet port
ISL LonWorks protocol, FTT-10 serial interface
ISS SNMP protocol, Ethernet port
IAV Remote set-point, 0-10 V signal
IAA Remote set-point, 4-20 mA signal
IAS Remote signal for second set-point activation
IDL Demand limit from digital input
IVE 0-10 V signal for the management of the 3-Way electronic pressostatic valve for
0-10 V signal for the management of the 3-Way electronic pressostatic valve for cold
IVC
evaporation control
start
Loose accessories
MN High and low pressure gauges
CR Remote control panel
AG Rubber shock absorbers
AM Spring shock absorbers

1.5 Compliance

The device complies with the following regulations:
• Machinery Directive 2006/42/CE
• PED Directive 2014/68/EU
• Electromagnetic Compatibility Directive 2014/30/UE
• LVD Directive: 2014/35/UE
• Energy Using Product directive 2009/125/EU and implementing regulations

1.6 Machine identification

A Packaging plate
B Frame feature plate
C Electrical board feature plate
The equipment can be identified from:
• Packaging plate.
- It shows the identification data of the equipment.
• Frame feature plate.
- Affixed on the machine, it shows the technical and performance data of the equipment.
• Electrical board feature plate.
- Affixed on the panel from which the electrical board is accessed, it shows the electrical
data of the equipment.
If it is lost or deteriorated, request a duplicate from Technical Support.
Tampering with, removal and deterioration of the identification plates complicate any
installation, maintenance and spare part request.

1.7 Intended use

This unit is designed to heat water (possibly added with inhibited ethylene glycol) which
circulates in a closed circuit.
The hot water produced can be used for air conditioning systems or for industrial processes.
The machine cannot be installed outdoors.
Any other use of the machine is forbidden.
Do not use flammable products near the machine.
Do not use substances that can form explosive mixtures close to the machine.
Do not use the machine where there are problems of environmental impact.
5