Wan Ipv6 Setting; Dhcp - Planet ICG-2515-NR Series User Manual

4.5.7 WAN IPv6 Setting

This page is used to configure parameter for IPv6 internet network which connects to WAN port of the
cellular gateway as shown in
parameters of the cellular gateway's WAN. In this setting you may change WAN connection type and
other settings.
Object
Connection Type
IPv6 Address
Subnet Prefix Length
Default Gateway

4.5.8 DHCP

The DHCP service allows you to control the IP address configuration of all your network devices. When
a client (host or other device such as networked printer, etc.) joins your network it will automatically get
a valid IP address from a range of addresses and other settings from the DHCP service. The client
must be configured to use DHCP; this is something called "automatic network configuration" and is
often the default setting. The setup is shown in
Figure 4-5-9. It allows you to enable IPv6 function and set up the
Figure 4-5-9: IPv6 WAN setup
Select IPv6 WAN type either by using DHCP or Static.
Enter the WAN IPv6 address.
Enter the subnet prefix length.
Enter the default gateway of the WAN port.
Figure
- 73 -
Industrial 5G NR Cellular Gateway
Description
4-5-10.
ICG-2515-NR series