Dynamic Select Controller - Mercedes-Benz Mercedes-AMG GT Owner's Manual

DYNAMIC SELECT controller

108
Problem
The engine is not running
smoothly and is misfir-
ing.
The coolant temperature
display is showing more
than 120 †. A display
message may also
appear on the multifunc-
tion display and a warn-
ing tone may sound.
DYNAMIC SELECT controller
General notes
Select the drive program using the DYNAMIC
SELECT controller.
Available drive programs:
C Comfort
S Sport
S+ SportPlus
RACE
(AMG GT S)
I Individual
Possible causes/consequences and M M Solutions
The engine electronics or a mechanical component of the engine
management system are/is malfunctioning.
Depress the accelerator pedal only slightly.
X
Otherwise, non-combusted fuel may get into the catalytic converter
and damage it.
Have the cause rectified immediately at a qualified specialist work-
X
shop.
The coolant level is too low. The coolant is too hot and the engine is not
being cooled sufficiently.
Stop as soon as possible and allow the engine and the coolant to
X
cool down.
Check the coolant level (
X
as you do so and top up the coolant if necessary.
If the coolant level is correct, the engine radiator fan may be faulty. The
coolant is too hot and the engine is not being cooled sufficiently.
If the coolant temperature is below 120 †, you can continue driving
X
to the nearest qualified specialist workshop.
Avoid heavy loads on the engine as you do so, e.g. driving in moun-
X
tainous terrain and stop-start traffic.
Comfort-orientated, engine
and transmission settings
optimised for economy
Sporty engine and transmis-
sion settings
Especially sporty engine and
transmission settings
Maximum sportiness and
engine and transmission
settings suitable for the
racetrack
Individual settings
page 235). Observe the warning notes
Y
Depending on the drive program selected, the
following vehicle characteristics will change:
the drive (engine management)
R
the transmission management
R
®
ESP ( page 57)
R
Y
the suspension ( page 140)
R
Y
the position of the exhaust flap
R
( page 106)
Y
the availability of the ECO start/stop function
R
( page 105)
Y
the availability of gliding mode
R
( page 112)
Y
Further information for automatic drive program
characteristics ( page 114).
Y
Additionally, in drive program I you can config-
ure the respective vehicle characteristics using
the multimedia system. You can find informa-
tion about this in the Digital Owner's Manual.
If the ignition is switched off for less than four
hours, the previously selected drive program is
activated when the engine is next started. If the
ignition is switched off for more than four hours,
drive program C is activated when the engine is
next started.