Table of Contents
Advertisement
To close manually: pull the corresponding
X
button and hold it.
To close fully: pull the button beyond the
X
point of resistance and release it.
Automatic operation is started.
To interrupt automatic operation: press/
X
pull the corresponding switch again.
If you press/pull the switch beyond the point of
resistance and release, automatic operation is
started in the corresponding direction. You can
stop automatic operation by pressing/pulling
again.
You can still operate the side windows when you
switch off the power supply or the ignition. This
function remains active for five minutes or until
you open a door.
Convenience opening feature
General notes
You can ventilate the vehicle before you start
driving.
If the key is in close proximity to the vehicle, the
convenience opening function is available.
To do so, open the side windows using the key.
The "convenience opening" feature is also avail-
able when the vehicle is unlocked.
Convenience opening feature
After unlocking the vehicle, press and hold
X
the % button on the key until the side win-
dows begin to open.
or
When the vehicle is unlocked, press and hold
X
the % button until the side windows have
reached the desired position.
To interrupt convenience opening: release
X
the % button.
Convenience closing feature
Important safety notes
G
WARNING
When using convenience closing, you could
become trapped within the sweep of the clos-
ing window. There is a risk of injury.
Monitor the entire closing procedure when
using convenience closing. When closing,
make sure that no one has any parts of the
body within the closing area.
When you lock the vehicle, you can close the
windows at the same time.
Using the key
Press and hold the & button until the side
X
windows are fully closed.
Make sure that all the side windows are
X
closed.
To interrupt convenience closing: release
X
the & button.
Using KEYLESS-GO
The driver's door and the door at which the han-
dle is used must both be closed. The key must be
outside the vehicle. The gap between the key
and the corresponding door handle should not
be greater than 1 m.
Touch recessed sensor surface : on the
X
door handle until the side windows are fully
closed.
Make sure you only touch recessed sensor
surface :.
Make sure that all the side windows are
X
closed.
To interrupt convenience closing: release
X
recessed sensor surface : on the door han-
dle.
Resetting the side windows
If a side window can no longer be closed fully,
you must reset it.
Side windows
Z
75
Advertisement
Table of Contents
