Care And Cleaning; Replacing The Batteries; Product Specifications - Braun TempleSwipe BST200 Manual

Care and cleaning

Use an alcohol swab or cotton swab moistened with alcohol (70% Isopropyl) to clean the
thermometer casing and the measuring probe. Ensure that no liquid enters the interior of the
thermometer. NEVER use abrasive cleaning agents, thinners or benzene for cleaning and
NEVER immerse the instrument in water or other cleaning liquids. Take care not to scratch the
surface of the lens by replacing the protective cap after use.

Replacing the batteries

The TempleSwipe™ Thermometer comes with 2 AAA
batteries.
To install the batteries, slide open the battery door as
shown. Insert 2 AAA batteries, correctly positioning
with positive "+" and negative "-" as shown. Replace
the battery door and close securely.
Replace the batteries when the flashing battery
symbol appears on the LCD screen. Dispose of batteries according to local waste
management directions.
To protect the environment, dispose of empty batteries at appropriate collection sites
according to national or local regulations.

Product specifications

Type: Temporal swipe thermometer
Measuring range: 34 °C – 42.2 °C (93.2 °F – 108 °F)
Resolution: 0.1°C (0.1 °F)
Accuracy (Laboratory) ±0.2°C for 35.0°C to 42.0°C
(±0.4°F for 95.0°F to 107.6°F)
Clinical accuracy and procedures ±0.3°C (±0.5°F) outside of this range are available
upon request.
Display: Liquid Crystal Display, 4 digits plus special icons
Acoustic: Audio:
Single long beep for 2 sec duration
Operating temperature: 15 °C – 40 °C (59 °F – 104.0 °F)
Automatic Switch-off: Approx. 60 seconds after last measurement has
been taken
Weight: 92g (±5g) (with batteries), 69g (±5g) (w/o batteries)
Long term storage ranges
Storage/transport temperature: –25 °C to 55 °C (–13 °F to 131 °F)
Humidity: 15–95% non condensing
Battery: (2) AAA Batteries - at least 1000 measurements
Pressure: 700-1060 hPA (0.7-1.06 atm)
This thermometer is an adjusted mode thermometer that provides an oral equivalent reading.
8
Equipment with See Instruction for use Operating temperature
type BF applied parts
LOT SN
Caution Batch code Serial number
Manufacturer Date of manufacture Authorized representative in the
European Community
Internally Powered Equipment
Continuous Operation
IP22: Protected against solid foreign objects of 12.5 mm diameter and greater. Protected
against vertically falling water drops when the device is tilted up to 15 degrees.
MEDICAL ELECTRICAL EQUIPMENT needs special precautions regarding EMC. NOTE: Do not
use this device in the presence of electromagnetic or other interference outside the normal
range specified in EN 60601-1-2. For detailed description of EMC requirements please please
visit website (Support / Document center) or contact service center. Portable and mobile RF
communications equipment can affect MEDICAL ELECTRICAL EQUIPMENT.
Clinical accuracy and procedures are available upon request.
This medical device carries the CE mark and is manufactured in conformity with RoHS
Directive 2011/65/EU and other applicable directive and/or regulations as specified in the EU
Declaration of Conformity.
E 1965-98 for the thermometer system. Full responsibility for the conformance of the product
to the standard is assumed by Kaz Europe Sarl, Place Chauderon 18, CH-1003 Lausanne,
Switzerland.
ASTM laboratory accuracy requirements in the display range of 37 to 39°C (98 to 102°F) for IR
thermometers is ±0.2°C (±0.4°F), whereas for mercury-in-glass and electronic thermometers,
the requirement per ASTM Standards E667-86 and E1112-86 is ±0.1°C (±0.2°F).
Please do not dispose of the product in the household waste at the end of its useful life.
Disposal can take place at your local retailer or at appropriate collection points
provided in your country.
English
Storage temperature Operating and storage humidity
REF MD
Catalogue number Medical device
9