How To Use - JUKI AP-876 Instruction Manual

5. How to use

Pattern number reading by means of the bar code is "only enabled under the pattern replacement
mode".
B
Pattern replacement
mode screen
List of error codes
Error code Pictograph
E010
E058
E921
1) Activating the pattern change mode
When the MODE key
mode button
button is pressed, the pattern change mode screen is dis-
A
played.
2) Under the bar code mode, bar code mode display
is shown on the screen.
Only when the pattern replacement mode screen is dis-
played, the scanning laser is emitted from the bar code
reader to enable reading of the bar code.
Once the bar code is scanned properly, the scanning laser
from the bar code reader stops.
Error content
The pattern designated by bar code is
not registered.
There is no bar code at the reading
position. Bar code decoding failed.
Communication time out.
Bar code reader is not connected to
the sewing machine. Bar code format
error.
– 4 –
is pressed, the pattern change
A is displayed on the screen. When this
Displayed How to
message recover
Designated Possible
pattern does not to re-
exist. start after
reset.
Bar code Possible
reading error to re-
start after
reset.
Bar code reader Turn OFF
communication the power
error
B
Place of
recovery
Previous
screen
Previous
screen