Table of Contents
Advertisement
Getting help
If you are using an external display, check that it is plugged into a power source and turned on. Check
that you have switched to the external display and that the brightness and contrast controls are adjusted
correctly.
Moisture condensation may have occurred. Leave the computer off for at least one hour and then turn
it on.
If the message Press <F1> to resume, <F2> to setup appears at the bottom of the display, you need
to initialize the BIOS.
Take the battery pack off the notebook, unplug the power cord and plug it in again, then turn on the
power.
The message 'Press <F1> to resume, <F2> to setup' appears at startup
If the floppy disk drive is empty, proceed as follows to initialize the BIOS:
1
Turn off the computer.
2
Remove any peripheral devices connected to the computer.
3
Turn on the computer and press <F2> when the Sony logo appears.
The BIOS setup menu screen appears.
4
Set the date (month/day/year).
5
Press Enter.
6
Press the arrow keys to select System Time.
7
Set the time (hour:minute:second).
8
Press Enter.
9
Press the arrow keys to select the Exit menu.
10
Press the arrow keys to select Get Default Values and then press <Enter>. The message Load default
configuration now? appears.
11
Make sure that Yes is selected and then press <Enter>.
n N
83
Hide quick links:
Advertisement
Table of Contents
