Advertisement
3
Install the Strike Plate
Parts needed for this procedure:
1
Strike plate
2
Bolt
2
Hex nut
Procedure
1.
Close the glove box cover, and mark the location
of the notch at the top of the glove box.
2.
Align the notch on the front of the strike plate
with the mark made in step 1.
3.
Mark the location of the holes on the strike plate.
4.
Using the marks made in step
drill 2 holes with 3/16 inch diameters to fit the
bolts.
5.
Clean any burrs from the drilled holes.
6.
Remove the hood from the machine, refer to
your Operator's Manual.
7.
Install the strike plate to the ceiling of the glove
box using 2 screws and hex nuts
Figure
5.
3
as a template,
Figure 4
Figure 4
1. Back of glove box
2. Screw
Note:
You may also remove the dash
reinforcement to improve clearance.
and
g233685
3
Figure 5
3. Nut
g233793
Advertisement
