Zanussi ZWF143A2DG User Manual page 20

The AutoAdjust detection is carried
out with complete washing
programmes only and if the
programme duration has not been
reduced by means of the FlexiTime
button.
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
When the programme is running, you can change
only some options:
1. Touch the Start/Pause
The related indicator flashes.
2. Change the options. The given information in
the display changes accordingly.
3. Touch the button Start/Pause
The washing programme continues.
CANCELLING A RUNNING PROGRAMME
1. Press the button ON/OFF to cancel the
programme and to deactivate the appliance.
2. Press the button ON/OFF again to activate the
appliance.
If the AutoAdjust System has
completed and the water filling has
already started, the new programme
starts without repeating the
AutoAdjust System. The water and
the detergent are not drained out in
order to avoid waste. The display
shows the maximum duration of the
programme, updating it about 20
minutes after the starting of the new
programme.
There is also an alternative way of cancelling:
1. Rotate the selector knob to the "Reset" position
.
2. Wait for 1 second. The display shows
Now, you can set a new washing programme.
OPENING THE DOOR - ADDING GARMENTS
If the temperature and level of the
water in the drum are too high and/or
the drum is still rotating you should not
open the door.
While a programme or the delay start operates, the
appliance door is locked. The display shows the
indicator .
1. Touch the Start/Pause
20
button.
again.
.
button.
In the display the related door lock indicator goes
off.
2. Open the appliance door. If necessary, add or
remove the items. Close the door and touch
the Start/Pause
The programme or the delay start continues.
END OF THE PROGRAMME
When the programme has finished, the appliance
stops automatically. The acoustic signals operate (if
they are active). The display shows
The indicator of the Start/Pause
off.
The door unlocks and the indicator
1. Press button ON/OFF to deactivate the
appliance.
After five minutes from the end of the programme,
the energy saving function automatically
deactivates the appliance.
When you activate the appliance
again, the display shows the end of
the previous programme. Turn the
programme dial to set a new cycle.
2. Remove the laundry from the appliance.
3. Make sure that the drum is empty.
4. Keep the door and the detergent dispenser
slightly ajar to prevent mildew and odours.
5. Close the water tap.
DRAINING WATER OUT AFTER END OF
CYCLE
If you have chosen a programme or an option that
does not empty out the water of the last rinse, the
programme is completed, but:
• The time area shows
shows the door locked
• The drum still turns at regular intervals to
prevent creases in the laundry.
• The door stays locked.
button.
button goes
goes off.
and the display
.