Error Messages Are Displayed - AEG OKO_FAVORIT 6281 I User Instructions

Operating instructions

...Error Messages Are Displayed.

• If fault code (2 is displayed on the multi-display or the
is illuminated, you can probably rectify the fault yourself.
After rectifying a (2 fault and a fault related to the
press the button for the wash programme that has been started. The
wash programme continues. If the fault code is displayed again, con-
tact customer service.
• For all other faults, please contact customer service, stating the fault
code.
Malfunction
The programme indica-
tor for the selected
programme is flashing
^
and the
illuminated:
there is no water run-
ning into the dish-
washer.
Fault code (2 is dis-
played on the multi-
display.
The programme indica-
tor for the selected
wash programme is
flashing.
Fault code (3 is dis-
played on the multi-
display.
[
The indicator is
illuminated.
28
Possible Cause
Tap is closed.
The filter (where present) in
the threaded hose fitting at
indicator is
the water inlet valve is
blocked.
The water inlet hose is not
correctly laid.
The siphon is blocked.
The water drain hose is not
correctly laid.
The leak prevention system
has been triggered.
[
The
intended to remind you to
check the filter in the dish-
washer from time to time
and, if necessary, to clean it.
It illuminates at regular
intervals, independent of the
amount of soiling of the fil-
ter.
indicator is only
^
indicator
^
indicator,
Remedy
Open tap.
Clean the filter in the
threaded hose fitting.
Check hose installation.
Clean siphon.
Check hose installation.
Close the tap and contact
customer service.
The indicator goes out auto-
matically on the start of the
next wash programme.