Table of Contents
Advertisement
Connecting the Dishwasher
Water connection
The dishwasher is fitted with safety devices that prevent the return of
wash water into the drinking water system and comply with the appli-
cable plumbing regulations.
• The dishwasher can be connected to cold and hot water supplies up
to max. 60 °C.
• The dishwasher must not be connected to open hot water appliances
or instantaneous water heaters.
Permitted water pressure
Lowest permitted water pressure:
1 bar (=10N/cm2 =100 kPa)
Highest permitted water pressure:
10 bar (=100 N/cm2 =1 MPa)
Connect the inlet hose
The water inlet hose must not be kinked, crushed or entangled when it
1
is being connected up.
0
Connect the threaded hose fitting (DIN 259) on the water inlet hose to
a tap with an external thread (¾ inch). Tighten the threaded hose fit-
ting only by hand.
• In order that access to the tap in the kitchen is not limited by the use
3
of the dishwasher, we recommend the installation of an additional
tap, or the fitting a two way adapter to the existing tap.
• If you need a longer water inlet hose than that supplied, the follow-
ing VDE approved complete hose sets are to be used, these are availa-
ble from your dealer:
– Hose set "WRflex 100" (E No.: 911 239 034)
– Hose set "WRflex 200" (E No.: 911 239 035)
Installation and Connection Instructions
For a water pressure of less than 2 bar
please seek advice from customer service.
In the case of a water pressure greater
than 10 bar, a pressure reduction valve
must be used (available from your
dealer).
35
Hide quick links:
Advertisement
Table of Contents
