Table of Contents
Advertisement
ADJUSTMENT [LCD Color Television] ASIA_EU
C
D
E
F
E.g. If Bit D7-0 = 0101 1010, Hex data is 0x5A.
Exit from Service Mode
Pressing POWER button to turn off the TV once.
Initialization of Memory Data of QA02 and Setting Data of Signal Unit
After replacing QA02 or signal board, the following initialization is required.
CAUTION: Never attempt to initialize the data unless QA02 has been
replaced.
Whenever using new signal board to the set, setting the Model ID data
according to Panel option data.
1) Enter the service mode.
2) Select menu of ID by pressing P
service mode.
3) Change ID data into MODEL ID to initialize by pressing
below.
4) Press and hold the CALL button on the remote control, then press the CHANNEL
button on the TV.
5) Initialization progress dialog including model name and panel vendor is shown.
Progress status is "WRITING".
file://C:\Documents and Settings\Alexsandr\Local Settings\Temp\Rar$EXa1.009\40X...
0
1
1
0
1
1
1
1
1
1
1
1
or P
during display of adjustment menu in the
0
1
0
1
+ or
-, refer to table
Стр. 8 из 21
16.05.2015
Advertisement
Table of Contents
