Source Menu; Alternate Source Menu By Tv/Source Key - Zenith Presentation Series Service Manual

Parental Lockout Is Active
01:23 Hours Remaining

SOURCE MENU

This option allows the user to select the source they
desire, which determines the signal that feeds the video
processor, the options are: ANTENNA/CABLE, AUX VIDEO
or VIDEO, CAMPORT, FRONT COMPUTER SVGA, REAR
COMPUTER SVGA, and REAR COMPUTER NTSC OUT.
Use the arrow keys and the ENTER key for signal switching.
SOURCE MENU
ANTENNA/CABLE
CAMPORT
AUX VIDEO
S-VIDEO
FRONT COMPUTER SVGA
REAR COMPUTER SVGA
REAR COMPUTER NTSC OUT
PRESS
PRESS ENTER OR <>KEYS TO ACTIVATE
SOURCE MENU

ALTERNATE SOURCE MENU BY TV/SOURCE KEY

Same as source menu, but using the TV/SOURCE Key.
Note: CAMPORT (#33) and FRONT COMPUTER SVGA (#209)
are only available when the Auto-Sense feature
for either has been disabled in the Factory Menu.
SR23 - 923-03509
USER MENUS 905-10533
CH 4
3:35 PM
MONO
TO CHANGE.
FRONT COMPUTER SVGA
PRESS:
SOURCE TO CHANGE SOURCE
ENTER TO SELECT SOURCE
To select a Source, press the Source Key and source menu
appears (as shown below) showing the present source.
Pressing the Source key again, switches to the next source
but the input signal does not change. Once the desired
source is found, pressing the ENTER key selects that source
and changes the input. If ENTER is not pressed in
approximately 15 sec. The source menu turns off.
Note: If any one of the three computer sources is selected
and no computer is connected to the source, the
following screen will appear:
PLEASE CONNECT A COMPUTER
MUTE
When the Mute key is pressed, the speakers will be turned
off.
MUTE WITH CHANNEL DISPLAY
When the mute key is pressed and the channel display
is on, the following display appears:
1-16
SOURCE
F COMP SVGA
1:51PM
STEREO
800 X 600, 60HZ
CS - MENUS