Heat & Glo 6000G Installation Instructions

For Valencia door see Pages 2-3.
WARNING
HOT SURFACES!
Glass and other surfaces are hot during
operation AND cool down.
Hot glass will cause burns.
• Do not touch glass until it is cooled
• NEVER allow children to touch glass
• Keep children away
• CAREFULLY SUPERVISE children in same room as
fi replace.
• Alert children and adults to hazards of high temperatures.
High temperatures may ignite clothing or other
fl ammable materials.
• Keep clothing, furniture, draperies and other fl ammable
materials away.
This appliance has been supplied with an integral barrier
to prevent direct contact with the fi xed glass panel. Do
NOT operate the appliance with the barrier removed.
Contact your dealer or Hearth & Home Technologies if the
barrier is not present or help is needed to properly install one.
Remove all materials from the packaging. It is very impor-
tant to know what kind of fi nishing materials are going to
be used on the fi replace. The doors are made to overlap
fi nishing material up to 1 in. thick (see Figure 1).
Figure 1. Overlap Fit Door
The doors can be used as an inside fi t for fi nishing materials
over 1 in. thick (see Figure 2). A template is available to
assist with proper sizing of the fi nishing material.
1. Remove all materials from the packaging.
2. Install the black shoulder bolts into the four threaded
inserts located in the fi replace surround.
3. Install the lower valve shield by screwing two self tapping
screws through the holes in the vanity panel into the pilot
holes in the fi replace surround (see Figure 3). Note: When
installing the Hi/Low solenoid, bend the metal tab in the
lower valve shield up to clear the solenoid.
4. Install the valve shield by hooking the "J" hooks into the
small slots on the back side on the lower valve shield.
1
Arcadia and Chateau Doors
Models: 6000G, 6000GL, 60000GLX, BE-41C
- Installation Instructions -
Heat & Glo • Arcadia, Chateau, Valencia Doors • 2101-931 Rev. E • 5/11
5. Hang the door on the four shoulder bolts. Push the door
in until it contacts the fi nishing material (overlap fi t) or
the fi replace surround (inside fi t).
FINISHING
MATERIAL
DOOR
37-1/4 in.
(Includes 1/8 in. opening each side of door)
37 in.
(Outside door width)
37-1/4 in.
(Includes 1/8 in. opening each side of door)
Figure 2. Inside fi t door
DOOR
Figure 3.
Cleaning Instructions for Doors
Use a microfi ber cloth and Windex® Original Glass
Cleaner or 03M003 Stove Bright® Glass Cleaner to clean
the door immediately after installation to remove acids
deposited by the installer or technician. Spray the cleaner
onto the microfi ber cloth and carefully wipe the entire
surface. The door should be cleaned in this manner
annually by the homeowner to remove fi ngerprints or
other contaminants. Once oxidation of the paint pigment
has occurred, cleaning will not restore the original color.
ELBOW
HEAT
FINISHING
SHIELD
MATERIAL
37 in.
(Outside door width)
33-3/4 in.
34 in.
UPPER
VALVE
SHIELD
"J" HOOKS
SLOTS
LOWER
VALVE
SHIELD