Heat & Glo 6000G Installation Instructions page 2

Models: 6000G, 6000GL, 60000GLX, BE-41C, SL-36-Ultimate
For Arcadia and Chateau doors see Page 1.
WARNING
HOT SURFACES!
Glass and other surfaces are hot during
operation AND cool down.
Hot glass will cause burns.
• DO NOT touch glass until it is cooled
• NEVER allow children to touch glass
• Keep children away
• CAREFULLY SUPERVISE children in same room as
fi replace.
• Alert children and adults to hazards of high temperatures.
High temperatures may ignite clothing or other
fl ammable materials.
• Keep clothing, furniture, draperies and other fl ammable
materials away.
• Do NOT operate with protective barriers open or removed.
• The doors must remain closed if children will be present
during the operation of the fi replace.
• The doors may be made operable per these instructions.
This may be done only upon request of a person responsible
for the use and operation of the fi replace.
• The doors can be returned to the locked position following
these instructions.
• These instructions are to be left with a person responsible
for the use and operation of the fi replace.
• When the doors are in an operable state, the door-locking
screw must be retained in the threaded nut behind doors.
Remove all materials from the packaging. It is very impor-
tant to know what kind of fi nishing materials are going to
be used on the fi replace. The doors are made to overlap
fi nishing material up to 1 in. thick (see Figure 1).
Figure 1. Overlap Fit Door
The doors can be used as an inside fi t for fi nishing materials
over 1 in. thick (see Figure 2). A template is available to
assist with proper sizing of the fi nishing material.
2
Valencia Doors
- Installation Instructions -
Heat & Glo • Arcadia, Chateau, Valencia Doors • 2101-931 Rev. E • 5/11
FINISHING
MATERIAL
DOOR
37-1/4 in.
(Includes 1/8 in. opening each side of door)
(Outside door width)
37-1/4 in.
(Includes 1/8 in. opening each side of door)
Figure 2. Inside fi t door
1. Remove all materials from the packaging.
2. Install the bolts into the four threaded inserts located in
the fi replace surround. Put the shoulder bolts in the lower
inserts. The phillips head bolts go in the top inserts.
3. Install the lower valve shield by screwing two self tapping
screws through the holes in the vanity panel into the pilot
holes in the fi replace surround (see Figure 3). Note:
When installing the Hi/Low solenoid, bend the metal tab
in the lower valve shield up to clear the solenoid.
4. Install the valve shield by hooking the "J" hooks into the
small slots on the back side on the lower valve shield.
5. Using a pliers, separate the front door panel and back
door panel by bending up the two tabs from the top "J"
hooks and lifting the front door panel to unhook. The
two tabs can be bent straight or broke off.
6. Hang the back door panel on the four bolts. Push the
door in until it contacts the fi nishing material (overlap
fi t) or the fi replace surround (inside fi t). Tighten the top
phillips bolts fi rmly.
7. Hang the front door panel on the back door panel by
hooking the "J" hooks through the slots in the back panel.
ELBOW
HEAT
FINISHING
SHIELD
MATERIAL
37 in.
(Outside door width)
33-3/4 in.
34 in.
37 in.