To Stop The Product; To Switch Off The Product; To Charge The Battery - Husqvarna Automower 550 EPOS Operator's Manual

operation mode is selected and the START button is
pushed.
4.4.2 Select duration
The product goes back to the charging station and stays
for the selected park duration. Use the operation
selection to temporary stop an ongoing mowing cycle
and let the product to stay in the charging station.
4.4.3 Operating mode - Pause
Pause in the Automower
When selecting
the product stop the current activity and pause. The
product is paused until either
®
the Automower Connect app.

4.5 To stop the product

1. Push the STOP button on top of the product.
The product stops and the cutting motor stops.
Note:
When you push the START button again, the
product continues to operate in the same operating
mode as before.

4.6 To switch off the product

1. Push the STOP button on top of the product.
®
2. Enter the Automower Connect app and connect
to the product with Bluetooth
Note:
If the product is not connected to
®
Automower Connect with Bluetooth
setting the Main switch to 0, the product is disabled
but not switched off. When the product is disabled
the motors are not allowed to run.
3. Set the Main switch to position 0.
24 - Operation
®
Connect app,
Park or Start is selected in
®
short-range.
®
when
WARNING:
product using the Main switch if it requires
maintenance, or if the product must be
moved outside the work area.

4.7 To charge the battery

WARNING:
using a charging station which is intended
for it. Incorrect use may result in electric
shock, overheating or leakage of corrosive
liquid from the battery.
In the event of leakage of electrolyte flush
with water and seek medical help if it comes
in contact with the eyes etc.
When the product is new or has been in storage for a
long period, the battery can be empty, charge the
battery before you start the product.
1. Set the Main switch to position
2. Put the product in as far as possible in the
charging station. Make sure that the product and
the charging station is connected. Refer to contact
Product overview on page 5 .
and charging strips in
3. Make sure that the charging is in progress in the
Automower ® Connect app.
Always switch off the
Only charge the product
1 .
1576 - 004 - 16.11.2021