After Use - Panasonic EW-DL83 Operating Instructions Manual

After use

Cleaning the brush head and the main unit
1
Remove the brush head.
• Remove the brush head straight
from the toothbrush shaft.
2
Wash the brush head under
running water�
Wash the following parts thoroughly:
• Soiling on the inside and bottom
areas of the brush head
Observe caution regarding the
following points:
• Do not pull the bristles of the brush
forcefully.
Otherwise, it will lead to bristle
falling off.
• Do not wash with water hotter than
80 °C.
Doing so may damage the brush
head.
EW-DL83(v5).indb 31
3
Wash the main unit under
running water�
• Do not damage or rub the
waterproof rubber seal ( )
with hard materials.
Do not leave the main unit
under water. Water may
enter inside.
• Do not wash with water
hotter than 40 °C.
Doing so may damage the
main unit.
4
Wipe off water from the brush head and main
unit for storage�
Do not charge while it is wet.
Doing so may cause soiling.
If the identification ring comes off
As shown in the diagram at right,
attach by aligning the indentation in
the brush head with the raised part of
the identification ring.
• Do not forcefully pull the identification
ring.
Doing so may cause damage.
• Using the toothbrush without the
identification ring has no effect on its
performance.

31
17/7/19 下午1:41