Table of Contents
Advertisement
INSTALLATION
4
4.1 MOVING AND POSITIONING THE UNIT
The units have been designed to be lifted from above by means of eyebolts and holes in the base members.
Use retractor bars to keep the lifting wires or chains away from the unit.
Correct lifting procedure
Figure 1
Lifting procedures provided with the unit have to be respected.
CAUTION!
Do not use forklift trucks to lift the unit from below. If equipment for lifting from above is not available, using rollers may move the unit.
The surface on which the unit is placed must be flat and strong enough to withstand the weight of the unit while running. In
order to reduce the transmission of vibrations to the supporting structures, fit shock absorbers in every fastening point.
Rubber shock absorbers are recommended for units installed on the ground, spring shock absorbers for units installed on
roofs. Open spaces around the unit must be provided to allow for the passage of necessary airflow and to allow normal
maintenance to be carried out.
IMPORTANT: Make sure that during transport the unit ALWAYS remains in the correct position.
Horizontal positioning of the unit can lead to irreversible damage to the compressors.
Damage arising from incorrect transport will not be under warranty by the manufacturer.
Immediately report an incorrect receipt of goods.
An arrow positioned upward indicates the vertical position of the unit.
Page 8
Advertisement
Table of Contents
