ADTRAN SFP+ Quick Start

Quick Start
The Enhanced Small Form-factor Pluggable SFP+ is a
single mode fiber optics that plugs into an ADTRAN optical
interface designed to accept SFPs. The SFP+ is an Indus-
trial Temperature (ITEMP) device that provides a single
optical interface to a physical interface, and is intended for
use with a 10 Gigabit Passive Optical Network (10G PON)
Optical Network Unit (ONU) unit. Installed into an appro-
priate ONT, the SFP+ provides a 10G XGS-PON interface
to the supporting system.
I
NSTALLATION
Before installing the equipment, inspect the SFP+. If
damage has occurred during shipping, file a claim with the
carrier, and then contact ADTRAN Customer Support. For
more information, refer to the warranty.
Installation Steps
To install the SFP+ into an appropriate device, complete
the following steps:
1. Insert the SFP+ into the SFP+ cage on the module.
Ensuring that the latch on the SFP+ is facing upward,
slide the SFP+ all the way into the SFP+ cage until
there is an audible "click".
g
NOTE
The latch on the SFP+ is for removal only. When removing
the SFP+, rotate the latch away from the SFP+. It should
easily slide out of the cage.
w
NOTICE
Do not remove the dust cover until the optical fiber
connection is made. Ensure that you keep the dust cover
on whenever the transceiver optical fiber connector is not
inserted.
2. Continue the installation and turn-up of the host
module using the instructions in the Job Aid or Quick
Start provided with the module or other system-level
documentation available online at www.adtran.com.
ADTRAN Pluggable Optics
SFP+
10 Gig XGS-PON ONU ITEMP
S
PECIFICATIONS
General
■ Module Type: SFP+
■ Media Type: Fiber
♦ Single Mode Fiber
♦ Single Fiber
■ Signal Data Rate:
♦ Upstream: 9.9532 Gbps
♦ Downstream: 9.9532 Gbps
■ Distance: 20 km
■ Applications: XGS-PON ONU
■ Optical Connector: SC/UPC
Optical
■ Transmitter
♦ Laser Diode Type: DFB
♦ Transmit Central Wavelength: 1270 nm
♦ Tx Output Optical Power: +4.0 dBm to +9.0 dBm
♦ Tx Spectral Width: 1 nm
♦ SMSR: 30 dB
♦ Extinction Ratio: 6 dB
■ Receiver
♦ Type: CW APD/TIA
♦ Input Optical Power: –28.0 dBm to –8.0 dBm
♦ Receive Central Wavelength: 1577 nm
♦ Receiver Sensitivity: –28.0 dBm
♦ Receiver Overload: –8.0 dBm
Environmental
■ Protected Equipment Severe Environment (Outdoor)
System Ambient Operational temperature range:
♦
–40°C to +70°C
♦ Storage temperature range: –40°C to +85°C
♦ Relative humidity 5 to 95%, noncondensing
January 2020
61200488F3-13A
P/N: 1200488F3