Assembly And Set Up; Clock Battery - Bosch GPB18V-2C Operating/Safety Instructions Manual

Functional Description and Specifications
Electrical Ratings
Memory
Ingress Protection
Allowed ambient
temperature
Please refer to the battery/charger list, included with your unit.

Clock Battery

replaced by an incorrect type. Use only
CR2032 batteries.
battery. Keep new and used batteri es
away from children.
This product contains a lithium
button/coin cell battery. If a new or
used lithium button/coin cell battery is
swallowed or enters the body, it can
cause severe internal burns and can
lead to death in as little as 2 hours.
Always completely secure the battery
compartment.
compartment does not close securely,
stop using the product, remove the
batteries, and keep it away from
children.
If you think batteries might have been
swallowed or placed inside any part of
the body, seek immediate medical
attention.
To install clock battery:
1. Release the locking latch 14 and
open battery bay door 13.
2. Remove clock battery cover 18 by
inserting a coin into the slot on the
cover and rotating the cover
counterclockwise (Fig. 2).
Radio
– during operation and storage
Battery Packs/Chargers

Assembly and Set Up

Risk of explosion if
the battery
Chemical Burn Haz -
ard. Do not ingest
If the
Voltage rating
IP Rating
– during charging
Fig. 2
is
3.
battery
4.
5.
6.
-9-
18 V
AM 530–1710 kHz
FM FM 87.5–107.9 MHz
AM 4 presets
FM 8 presets
IP54 only when battery bay
door is installed and closed.
32...95 °F (0...+35 °C)
–4...104 °F (–20...+40 °C)
If opening the battery compartment
for the first time, remove the clear
plastic strip 27. If replacing battery,
remove old battery and dispose of
properly (Fig. 2).
Insert (new) CR2032 battery 26.
Make sure that the positive (+) side
of the battery is facing up.
Replace clock battery cover by
inserting a coin into the slot on the
cover and rotating the cover
clockwise until the cover locks into
place.
To close the battery bay door, bring it
up against the seal on the housing
and lock it by placing the latch's
catch in the mating slot on the
housing and pressing the latch's lever
section.
18
26
27