Advertisement
* Software option for Function Change
- ON : With PIP Models (DTx-xxxxME seiese)
PIP
- OFF : Without PIP Models (DTx-xxxxMT seriese)
- ON : Enable the Digital Sensor (for all Model)
Digital EYE
- OFF : Disable the Digital Sensor
- ON : Enable the all Languge (for all models, except NEC)
Languge
- OFF : Enable the English
- ON : For 34 inch Models
34 Inch
- OFF : For 29 inch Models
LATIN : English,French,Swedish,Czech,German,Spanish,Italian,Estonian
EAST
RUSSIA : English,Russian,Bulgaian,Ukrainian,Serbian,Montenegro
TEXT sel.
PERSIAN : English,Farsi
ARAB
OFF
- ON : For PARS Elec.
PARS LOGO
- OFF : For all Model except PARS
- ON : For PARS Elec
TEXT DISP
- OFF : For all Model except PARS
- ON : CM-921F Chassis
EXT PORT
- OFF : CM-920F/W Chassis
2. The confirmation of Protection circuit
Protection circuit confirmation is omitted in case of mass production in the factory
2-1. Over Current Protecor (OCP) circuit confirmation
2-1-1. Receive PAL RETMA PATTERN(signal of company:2CH., PAL-B) and adjust
STANDARD MODE in PICTURE.
2-1-2. Connect 1MΩ 1/2W between BASE of Q807 and GND, to confirm operating of
PROTECTOR.
The next place, to confirm normal operation when the resister(1MΩ) is removed."
2-1-3. After Main Power Switch OFF/ON, to confirm normal operation of picture and
sound when turn the set on by remocon.
2-2. High Voltage Protecor (X-ray Protection) circuit confirmation.
2-2-1. Receive PAL RETMA PATTERN(signal of company:2CH., PAL-B), adjust
CONTRAST&BRIGHTNESS to minimun.
2-2-2. Connect 1/6W 15K ohm to R413(1/6W 24K ohm) of POWER PCB in parallel.
Confirm that operation of the SET is SHUT-DOWN condition(High Voltage
Protector).
2-2-3. The next place, to confirm normal operation when the resister(15KΩ) is removed."
2-2-4. After Main Power Switch OFF/ON, to confirm normal operation of picture and
sound when turn the set on by remocon.
: English, Slovakian,Hungarian,Serbian,Albanian,Polish,Turkian,Rumanian
: English,Arabic
: Teletext Language depends on OSD Language selection
Note : If OSD language & text selec. is different then Teletext depends on Text selec.
7
Alignment Instruction
It depends on Cabinet Design
- Multi OSD-Language
- Only English
Change the Vertical
Blanking puls width
Advertisement
