Nvm Default Setting - Daewoo DUX-21U7DT Service Manual

CP-530 Service Manual

3.6 NVM default setting

The purpose of this message, when you change a virgin EEPROM, is to allow to modify the
NVM DATA to desired values.
1 - Introduction :
The NVM default values are fixed for the user, but for flexibility in service, these data are stored
"NVM EDITOR" . This
in NVM and can be changed when the TV set is in a special mode call
mode can only be access from "FACTORY" mode.
2 - Entering into " " FACTORY" " mode.
To switch the TV set into FACTORY mode, use the factory remote control, and press on "SVC"
key. The factory menu will appear on the screen, showing "FACTORY", plus other relevant
information like software version and date.
WARNING : When in "FACTORY"mode you should not press any key other than the keys
described in the procedure below. Unwanted key stroke could misadjust the TV set.
3 - Entering into " " NVM EDITOR" " mode.
To switch the TV set into NVM EDITOR mode, use the user remote control, and press on "OK"
key. The NVM EDITOR window will appear on the screen. This mode allow you to access all
data stored in NVM. The current NVM address is given in column "ADDR."in both DECimal
and HEXadecimal format. The column DATA gives the value contained at selected address in
both DECimal and HEXadecimal format.
4 - Navigation in " " NVM EDITOR" " mode.
Use Program Up/Down keys to select the desired address. Use Volume Up/Down keys to
change the data at selected address. You must press "OK"key to store value after
modification.
The data can be adjusted between 0 and 63.
5 - Exit " " NVM EDITOR" " mode.
To switch the TV set back into FACTORY mode, use the user remote control, and press on
"MENU" key.
The factory menu will appear on the screen, showing "FACTORY" .
6 - Exit " " FACTORY" " mode.
To exit "FACTORY" mode, use the factory remote control, and press on "SVC" key.
The factory menu will disappear from the screen.
-12-