Sony DVP-NS92V Operating Instructions Manual page 25

7
Press X/x to select the setting that
matches your TV type.
If you have a wide-screen TV or a 4:3
standard TV with a wide-screen mode
• 16:9 (page 74)
If you have a 4:3 standard TV
• 4:3 LETTER BOX or 4:3 PAN SCAN
(page 74)
8
Press ENTER.
The Setup Display for selecting the type
of jack used to connect your amplifier
(receiver) appears.
Is this player connected to an amplifier
(receiver) ? Select the type of jack you
are using.
YES
LINE OUTPUT L/R (AUDIO)
DIGITAL OUTPUT
DIGITAL & 5.1CH OUTPUT
NO
9
Press X/x to select the type of jack
(if any) you are using to connect to
an amplifier (receiver), then press
ENTER.
If you did not connect an AV amplifier
(receiver), select "NO," then go to step
19.
If you connected an AV amplifier
(receiver) using just an audio cord, select
"YES: LINE OUTPUT L/R (AUDIO),"
then go to step 19. If you connected an
AV amplifier (receiver) using either an
optical or coaxial digital/HDMI cord,
select "YES: DIGITAL OUTPUT." The
Setup Display for "DOLBY DIGITAL"
appears.
If you connected an AV amplifier
(receiver) using an audio cord, select
"YES : DIGITAL & 5.1CH OUTPUT."
The Setup Display for "DOLBY
DIGITAL" appears.
10
Press X/x to select the type of
Dolby Digital signal you wish to
send to your amplifier (receiver).
If your AV amplifier (receiver) has a
Dolby Digital decoder, select "DOLBY
DIGITAL." Otherwise, select "D-PCM."
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
AUDIO FILTER:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
MPEG:
DTS:
48kHz/96kHz PCM:
11
Press ENTER.
"DTS" is selected.
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
AUDIO FILTER:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
MPEG:
DTS:
48kHz/96kHz PCM:
12
Press X/x to select whether or
not you wish to send a DTS signal
to your amplifier (receiver).
If your AV amplifier (receiver) has a
DTS decoder, select "DTS." Otherwise,
select "D-PCM."
13
Press ENTER.
When "DIGITAL OUTPUT" is selected
in step 9
• Quick Setup is finished and
connections are complete.
• If your AV amplifier (receiver) has an
MPEG audio decoder, set "MPEG" to
"MPEG" (page 79).
When "DIGITAL & 5.1CH OUTPUT" is
selected in step 9
The Setup Display for "SPEAKER
SETUP" appears.
OFF
STANDARD
SHARP
DOLBY SURROUND
ON
D-PCM
D-PCM
DOLBY DIGITAL
48kHz/16bit
OFF
STANDARD
SHARP
DOLBY SURROUND
ON
D-PCM
DTS
D-PCM
48kHz/16 bit
,continued
25