Sony SA-VE702 Operating Instructions Manual page 6

Hooking up the system (continued)
Hookup C (SA-VE702 only)
This configuration is used when the amplifier is connected to a CD player, MD deck, cassette
deck, or other audio devices.
Front (Right)
Ee
Amplifier
Attach the front speakers to the supplied speaker stands for positioning. For details, see "Positioning the front
(and rear) speakers" on page 7.
Terminal connections
loosen
e
E
tighten
Notes
• Make sure the plus (+) and the minus (–) terminals on the speakers are matched to the corresponding the plus
(+) and the minus (–) terminals on the amplifier.
• Be sure to tighten the screws of the speaker terminals securely since loose screws may become a source of
noise.
• Make sure all connections are firm. Contact between bare speaker wires at the speaker terminals may cause a
short-circuit.
• Do not connect the subwoofer to the amplifier's CENTER output terminal (which is for Dolby Pro Logic or
Dolby Digital (AC-3)). No bass will output from the subwoofer if you do.
• For details regarding the connections on the amplifier side, refer to the manual that was provided with your
amplifier.
Tip
It is convenient to remember that all striped wires are minus (–) in polarity and should be connected to the
minus (–) speaker terminals.
6 GB
FRONT
R
eE Ee
e
e
E
E
Subwoofer
L
e
E
E
e
R
L
SPEAKER
IN
e
E
Front (Left)
Ee
L
R
SPEAKER
OUT