Listening to the FM/AM radio
For details on the tuner function, see "Tuner
Operations" (page 51).
Tuning radio stations
1
Press TUNER repeatedly to select the
FM or AM band.
You can also use INPUT SELECTOR +/–
on the receiver.
2
Press TUNING + or TUNING –.
Press TUNING + to scan from low to high
frequencies, press TUNING – to scan from
high to low frequencies. The receiver stops
scanning whenever a station is received.
Selecting a frequency directly
(Direct Tuning)
1
After selecting the FM or AM band,
press D.TUNING.
2
Press SHIFT, then press numeric
buttons to enter the frequency.
3
Press
.
Presetting radio stations
1
Tune in the station that you
want to preset.
For details on the operation, see "Tuning
radio stations" (page 84).
2
Press SHIFT, then press ENT/
MEM.
"MEM" lights up for a few seconds.
Perform steps 3 and 4 before "MEM"
disappears.
3
Press PRESET + or PRESET –
to select a preset number.
30 FM and 30 AM preset numbers are
available. If "MEM" disappears before
you select the preset number, start again
from step 2.
84
GB
4
Press ENT/MEM or b.
If SHIFT indicator is light off before you
press ENT/MEM, press SHIFT.
The station is stored as the selected preset
number.
If "MEM" disappears before you press
ENT/MEM, start again from step 2.
5
Repeat steps 1 to 4 to preset
another station.
Selecting a preset station
1
Press TUNER repeatedly to select the
FM or AM band.
2
Press PRESET + or PRESET –
repeatedly to select the preset station
you want.
You can also press SHIFT, then press
numeric buttons to select the preset station
you want. Then, press
selection.
to enter the