Specifications - Sony STR-DN1000 Operating Instructions Manual

Error messages
If there is a malfunction, the display shows a
message. You can check the condition of the
system by the message. See the following table
to solve the problem. If any problem persists,
consult your nearest Sony dealer.
PROTECTOR
Irregular current is output to the speakers, or
upper panel of the receiver is covered with
something. The receiver will automatically
turn off after a few seconds. Check the
speaker connection and turn on the power
again.
For other messages, see "Message list after
Auto Calibration measurement" (page 43) and
"DIGITAL MEDIA PORT message list"
(page 51).
Reference sections for clearing
the receiver's memory
If you are unable to remedy the problem using
the troubleshooting guide, clearing the
receiver's memory may remedy the problem
(page 35). However, note that all memorized
settings will be reset to their initial settings and
you will have to readjust all settings on the
receiver.
If the problem persist, consult your nearest
Sony dealer. Note that if service personnel
changes some parts during repair, these parts
may be retained.
In the event of a problem with S-AIR function,
have a Sony dealer check the entire system
together (S-AIR main unit and S-AIR sub
unit).
To clear
All memorized settings
Customized sound fields

Specifications

Amplifier section
Models of area code CEL, CEK, AU, E51
Minimum RMS Output Power
(8 ohms, 20 Hz – 20 kHz, THD 0.09%)
Stereo Mode Output Power
(8 ohms, 1 kHz, THD 1%)
Surround Mode Output Power
(8 ohms, 1 kHz, THD 10%)
1)
Measured under the following conditions:
Area code
CEL, CEK, AU
E51
2)
Reference power output for front, center, surround
and surround back speakers. Depending on the
sound field settings and the source, there may be
no sound output.
Frequency response
Analog
Input
Analog
Digital (Coaxial) Impedance: 75 ohms
Digital (Optical)
Output (Analog)
AUDIO OUT
See
SUBWOOFER
page 35
Equalizer
page 63
Gain levels
1)
85 W + 85 W
100 W + 100 W
2)
140 W per channel
Power requirements
230 V AC, 50 Hz
240 V AC, 50 Hz
10 Hz – 70 kHz,
+0.5/–2 dB (with sound
field and equalizer
bypassed)
Sensitivity: 500 mV/
50 kohms
3)
S/N : 96 dB
4)
(A, 500 mV )
S/N: 100 dB
(A, 20 kHz LPF)
S/N: 100 dB
(A, 20 kHz LPF)
Voltage: 500 mV/10 kohms
Voltage: 2 V/1 kohm
±10 dB, 1 dB step
continued
125 GB