Changing The Factory Setting Of An Input Selector Button - Sony STR-DE697 Operating Instructions Manual

Changing the factory
setting of an INPUT
SELECTOR button
If the factory settings of the INPUT SELECTOR
buttons do not match your system components,
you can change them. For example, if you have
an MD deck and a tape deck and you do not have
a CD player, you can assign the SA-CD button
to your tape deck.
Note that the settings of the TUNER button
cannot be changed.
1
Hold down the INPUT SELECTOR
button whose input you want to change
(for example, SA-CD).
2
Press the corresponding button of the
component you want to assign to the
INPUT SELECTOR button (for example,
6 – Tape deck).
The following buttons are assigned to select
the input:
To operate
CD player
MD deck
Tape deck A
Tape deck B
LD player
VCR (command mode VTR 1*)
VCR (command mode VTR 2*)
VCR (command mode VTR 3*)
TV
DSS (Digital Satellite Receiver)
DVD player
*Sony VCRs are operated with a VTR 1, 2 or 3
setting. These correspond to Beta, 8mm and
VHS respectively.
Now you can use the SA-CD button to
control the tape deck.
GB
46
To change the factory settings of
VIDEO 3 and AUX buttons
1
Hold down FN SHIFT and the INPUT
SELECTOR button you want to change
(for example, VIDEO 3 or AUX).
2
Press the corresponding button of the
component you want to assign to the
INPUT SELECTOR button.
To reset a button to its factory
setting
Repeat the above procedure.
To reset all the INPUT SELECTOR
buttons to their factory setting
Press ?/1, AV ?/1 and MASTER VOL – at the
same time.
Press
4
5
6
7
8
9
0
>10
ENTER
.
>