Specifications - Sony STR-DE697 Operating Instructions Manual

Top hi-fi range 7 x 100 w receiver with dolby digital es, dolby pro logic ii and dts ex decoder
Hide thumbs Also See for STR-DE697:
Table of Contents

Advertisement

Remote control
The remote does not function.
• Point the remote at the remote sensor
receiver.
• Remove any obstacles in the path between the
remote and the receiver.
• Replace all the batteries in the remote with new
ones, if they are weak.
• Make sure you select the correct input on the
remote.
Error messages
If there is a malfunction, the display shows a
message. You can check the condition of the
receiver by the message. Refer to the following
table to solve the problem.
DEC. EROR
Appears when the signal which the receiver cannot
decode (ex. DTS-CD) is input when "DEC. XXXX"
is set to "DEC. PCM". Set to "DEC. AUTO".
PROTECT
Irregular current is output from the speakers. The
receiver will automatically turn off after a few
seconds. Check the speaker connection and turn on
the power again. If this problem persists, consult
your nearest Sony dealer.
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver's memory may remedy the
problem (page 17). However, note that all
memorized settings will be reset to their factory
settings and you will have to readjust all settings
on the receiver.
If the problem persist
Consult your nearest Sony dealer.
Reference sections for clearing
the receiver's memory
To clear
All memorized settings
Customized sound fields
GB
50

Specifications

on the
Amplifier section
Power Output
Models of area code CEL, CEK
Rated Power Output at Stereo Mode
(8 ohms 1 kHz, THD 0.7%)
Reference Power Output
(8 ohms 1 kHz, THD 0.7%)
FRONT
CENTER
SURR
SURR BACK
Models of area code SP
Rated Power Output at Stereo Mode
(8 ohms 1 kHz, THD 0.7%)
Reference Power Output
(8 ohms 1 kHz, THD 10%)
FRONT
CENTER
SURR
SURR BACK
Models of area code AU
Rated Power Output at Stereo Mode
(8 ohms 20 Hz – 20 kHz, THD 0.09%)
(8 ohms 1 kHz, THD 0.7%)
Reference Power Output
(8 ohms 20 Hz – 20 kHz, THD 0.09%)
FRONT
CENTER
SURR
SURR BACK
(8 ohms 1 kHz, THD 0.7%)
FRONT
CENTER
SURR
SURR BACK
(8 ohms 1 kHz, THD 10%)
See
FRONT
CENTER
page 17
SURR
page 36
SURR BACK
100 W + 100 W
1)
2)
:
100 W/ch
2)
:
100 W
2)
:
100 W/ch
2)
:
100 W/ch
100 W + 100 W
1)
2)
:
120 W/ch
2)
:
120 W
2)
:
120 W/ch
2)
:
120 W/ch
80 W + 80 W
100 W + 100 W
1)
2)
:
80 W/ch
2)
:
80 W
2)
:
80 W/ch
2)
:
80 W/ch
2)
:
100 W/ch
2)
:
100 W
2)
:
100 W/ch
2)
:
100 W/ch
2)
:
120 W/ch
2)
:
120 W
2)
:
120 W/ch
2)
:
120 W/ch
1)
1)
1)
1)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents