Changing The Factory Setting Of An Input Button - Sony STR-DE598 Operating Instructions Manual

Tips
• You need to assign a function to the VIDEO 3 button
before you can use the button to control your audio/
video equipment. For details, refer "Changing the
factory setting of an input button" on page 47.
• To activate the buttons with orange printing, press
TV and the button you want simultaneously.
• Before you use the V/v/B/b button for receiver
operation, press MAIN MENU. To operate other
components, press TOP MENU/GUIDE or AV
MENU after pressing the input button.
Notes
• When you press the input buttons (VIDEO 1, VIDEO
2, VIDEO 3, DVD), the input mode of the TV might
not switch to the corresponding input mode that you
want. In this case, press the TV/VIDEO button to
switch the input mode of the TV.
• Some functions explained in this section may not
work depending on the model.
• The above explanation is intended to serve as an
example only. Therefore, depending on the
component the above operation may not be possible
or may operate differently than described.
Changing the factory
setting of an input button
If the factory settings of the input buttons do not
match your system components, you can change
them. For example, if you have a tape deck and
you do not have an MD deck, you can assign the
MD/TAPE button to your tape deck.
1
Hold down the input button whose
input you want to change (for example,
MD/TAPE).
2
Press the corresponding button of the
component you want to assign to the
input button (for example, 7 – Tape
deck).
The following buttons are assigned to select
the input:
To operate
VCR (command mode VTR 3*)
VCR (command mode VTR 2*)
DVD player/DVD recorder
(command mode DVD1)
DVD recorder
(command mode DVD3)
CD player
MD deck
Tape deck B
Tuner (this receiver)
DSS (Digital Satellite Receiver)
DCS (Digital CS Tuner)
BSD (Digital BS Tuner)
*Sony VCRs are operated with a VTR 2 or 3
setting. These correspond to 8mm and VHS
respectively.
Now you can use the MD/TAPE button to
control the tape deck.
To reset a button to its factory
setting
Repeat the above procedure.
To reset all the input buttons to
their factory setting
Press ?/1, TEST TONE and MASTER VOL –
at the same time.
Press
1
2
3
4
5
6
7
8
9
0/10
-/--
47 GB