Mitsubishi Electric MSZ-WG18VA-H1 Operating And Installing Instructions page 38

Wall-mounted inverter heat pump room air conditioner
Table of Contents

Advertisement

Airflow velocity and direction adjustment
Movement of horizontal vane
Cooling/Dry
Horizontal position
·The vane moves to the horizontal position after stopping swing.
Note:
The airflow is higher than position 1.
1/2 or one
hour later
The airflow direction is set to position (2) , (3) or (4), (5)
·When the air conditioner operates for about one hour, the
vane moves to position (1) or (2) automatically. Press the
button Vane on the remote controller to change the airflow
direction back to original set point.
·The vane moves intermittently
between position (1) and (5). The
vane stays at position (1) and (5) for
a moment.
Note:
Adjust the airflow direction by the remote controller. Moving the vertical vane or
horizontal vane by hand may cause failure.
When the operation mode changes to mode "
to different positions automatically mentioned above.
Press button
to change airflow direction (left/right)
Each press of the button enables the unit to change the vertical vane angle following
the order of:
Blow with swing.
Blow with swing enables the airflow to reach each corner of the room.
Start of heating
Horizontal
position
·After the air conditioner starts to operate, the vane stops in horizontal position.
Once the temperature of the airflow from indoor unit is enough high, the vane
will move to Set position 4.
·Once the air conditioner starts to operate, fan speed increases with the
temperature rise of airflow from the indoor unit and until the set speed.
Start of heating
Horizontal position
Position (1) or (2)
·After the air conditioner starts to operate, the vane stops in horizontal position.
Once the temperature of the airflow from indoor unit is enough high, the vane
will move to Set position.
·Once the air conditioner starts to operate, fan speed increases with the
temperature rise of airflow from the indoor unit and until the set speed.
·The vane moves intermittently between position (2)
and (5). The vane stays at position (2) and (5) for
a moment.
(1)
(5)
(auto)", the horizontal vane changes
(Swing)
11
Heating
When the air is
hot...
Position 4
Horizontal
position
When the air is
hot...
Set position
(2)
(5)

Advertisement

Table of Contents
loading

Table of Contents