Table of Contents
Advertisement
16
www.electrolux.com
To set the heat setting use
two left side control bars.
Switching between the modes
To switch between the modes use
sensor field:
When you switch between
the modes the heat setting is
set back to 0.
Diameter and position of the
cookware
Choose the mode applicable to the size
and the shape of the cookware. The
cookware should cover the selected area
as much as possible. Place the
cookware centrally on the selected area!
Place the cookware with the bottom
diameter smaller than 160 mm centrally
on a single section.
Place the cookware with the bottom
diameter larger then 160 mm centrally
between two sections.
.
100-160mm
6.2 FlexiBridge Standard mode
This mode is active when you activate
the hob. It connects the sections into two
separate cooking zones. You can set the
heat setting for each zone separately.
Use two left side control bars.
Correct cookware position:
Incorrect cookware position:
> 160 mm
Advertisement
Table of Contents
