4: Preventing The Tv From Toppling Over; 5: Switching On The Tv - Sony Bravia KDF-E42A12U Operating Instructions Manual

1
Connect your aerial to the
rear of the TV.
If connecting to an aerial only (A)
Connect the socket to the
of the TV with the supplied coaxial cable.
Go to step 3.
If connecting to a VCR with an aerial (B)
Go to step 2.
2
Connect your VCR.
1 Connect the
the input socket on your VCR with the RF
lead.
2 Connect the output socket on your VCR to the
socket on the rear of the TV with the
supplied coaxial cable.
3 Connect the scart socket on your VCR to the
/ 2 scart socket on the rear of the TV
with a scart lead.
Note
Do not connect the mains lead to your mains socket until
all connections are complete.
3
Bundle the cable.
12
socket on the
socket on the rear
socket on the rear of the TV to
4: Preventing the TV
from toppling over
Sony strongly recommends using the TV stand SU-
RG11S (for KDF-E42A12U)/SU-RG11M (for KDF-
E50A12U) with a support belt designed for your TV.

5: Switching on the TV

P U S H O P E N T IM E R L A M P P O W E R /S T A N D B Y
W E G A G A T E
T V /V ID E O VO L U M E C A N N E L
2
1
Connect the TV to your mains socket (220-
240V AC, 50Hz).
2
Press 1 on the TV (front side).
When you switch on the TV for the first time, the
message confirming the TV start auto-tuning
appears on the screen.
When the TV is in standby mode (the 1 (standby)
indicator on the front of the TV is red), press TV
+/1 on the remote to switch on the TV, then go to
page 13.
1
P O W E R