Space Heating/Cooling Control; About Space Heating/Cooling Control; Setting The Space Operation Mode - Daikin Altherma 3 R F User Reference Manual

5 | Operation

5.6 Space heating/cooling control

5.6.1 About space heating/cooling control

5.6.2 Setting the space operation mode

User reference guide
26
Possible read-out information
In menu...
[8.1] Energy data
[8.2] Malfunction history
[8.3] Dealer information
[8.4] Sensors
[8.5] Actuators
[8.6] Operation modes
[8.7] About
[8.8] Connection status
[8.9] Running hours
Controlling space heating/cooling typically consists of the following stages:
1 Setting the space operation mode
2 Controlling the temperature
Depending on the system layout and installer configuration, you use a different
temperature control:
▪ Room thermostat control
▪ Leaving water temperature control
▪ External room thermostat control
About space operation modes
Your unit is a heating only model. The system can heat up a space, but NOT cool
down a space.
However, if the kit EKHVCONV* is installed, the system can cool down a space, and
you have to tell the system which space operation mode to use: heating or cooling.
To determine if a heating/cooling heat pump model is installed
1 Go to [4]: Space heating/cooling.
2 Check if [4.1] Operation mode is listed and editable. If so, a
heating/cooling heat pump model is installed.
You can read out...
Produced energy, consumed electricity,
and consumed gas
Malfunction history
Contact/helpdesk number
Room temperature, outside
temperature, leaving water
temperature,...
Status/mode of each actuator
Example: Unit pump ON/OFF
Current operation mode
Example: Defrost/oil return mode
Version information about the system
Information about the connection
status of the unit, the room thermostat
and WLAN.
Running hours of specific system
components
EBVZ16S18+23DJ
Daikin Altherma 3 R F
4P643608-1 – 2021.09