Table of Contents
Advertisement
INSTALLATION
Unpacking
1. Unpack the washing machine.
2. Check whether the washing machine has
been damaged during transport. If this is
the case, do not install it.
Remove the polystyrene base
The vertical block part of the base (see below)
should have stayed intact when the base was
removed. If it has broken off and is still inside
the machine, carefully lay the machine on its
side, onto the polystyrene top cap and then
remove the block.
Vertical block
Warning:
Packaging materials are not childrens toys.
Remove the transit fixings
Follow these instructions to remove the TWO
transit fixings. IMPORTANT: Situated one either
side of the rear panel, both transit bolts
(complete with spacers) MUST be removed
before use.
Failure to do so may cause damage to the
machine!
polystyrene
base
1. Use a crosshead
screwdriver to
remove the plastic
cover.
For safety, replace both plastic covers over
the holes left by removing the two bolts.
Levelling
1. Install the washing machine on a flat sturdy
floor, without resting it up against walls,
cabinets etc.
2. Compensate for any unevenness by
tightening or loosening the adjustable front
feet. The angle of inclination, measured
according to the worktop must not
exceed 2°.
Levelling the appliance correctly will provide it
with stability and avoid any vibrations, noise
and shifting during operation. If it is placed on
a fitted or loose carpet, adjust the feet in such
a way as to allow enough room for ventilation
beneath the washing machine.
7
2. Unscrew the bolt
using a 13 mm
spanner.
3. STOP when 3
threads can be
seen.
4. Hold, slide and pull
to remove.
! It is important the
transit bolt and
spacer come out
intact
(see image left).
Advertisement
Table of Contents
