Installation - Hotpoint WDL756PUK Service Information

Indesit Company

INSTALLATION

Unpacking
1. Unpack the washing machine and check whether the it has been damaged during transport.
If this is the case, do not install it and contact the retailer.
2. Remove the four protective screws (transit bolts) and the rubber washer with the respective
spacer, situated on the rear of the appliance (see Figures below).
3. Fit the blanking plugs provided into the holes vacated by the bolts.
3. Use the plug provided to seal the holes where the mains plug was housed (if supplied), situated on
the lower right hand side on the rear of the appliance.
4. Keep all the removed parts as they will be required again if the washing machine needs to be
moved to another location.
This raised part is attached to the polystyrene base
and should have been removed when unpacking.
Levelling
1. Install the washing machine on a flat sturdy floor, without resting it up against walls, cabinets etc.
2. Compensate for any unevenness by tightening or loosening the adjustable front feet. The angle of
inclination, measured according to the worktop must not exceed 2°.
Levelling the appliance correctly will provide it with stability and avoid vibrations, noise and shifting
during operation. If it is placed on a fitted or loose carpet, adjust the feet in such a way as to allow
enough room for ventilation underneath the appliance.
Connecting the water inlet hose.
Before making the water connection
to the 3/4" thread, allow the water
freely from the supply tap until it is
perfectly clear.
Check that seal is in place inside the
hose end cap.
Service Manual UK
Connect the other end of the water
inlet hose to the washing machine,
screwing it onto the cold water inlet,
situated on the top right-hand rear of
the appliance - see illustration above.
31 of 33
Remove 4 transit bolts.
Screw the inlet end with the blue cap
onto the cold water supply tap.Turn
the tap on and check for leaks:
tighten if necessary. Make sure there
are no kinks or bends in the hose.
The water pressure at the tap must
be within the values indicated in the
Specifications page.
English