Whirlpool UDT518SAHP Installation Instructions Manual page 19

Option B: No Waste disposer—no air gap
Waste tee
1. Fit rubber end of drain hose
1
to waste tee.
Rubber
end
2. Attach rubber end of drain hose to
2
waste tee with a hose clamp. Use a 1"
to 1 /
1
(not provided).
Option C: Waste disposer – with air gap
Screw-type clamps
Disposer inlet
Drain trap
Helpful Tip: Remove disposer knockout plug.
1. Using a hammer and screwdriver, knock
1
plug into disposer.
2. Use needle-nose pliers to remove plug.
2
3 3. Connect rubber end of drain hose
to air gap.
Rubber
end
Large drain
hose clamp
Drain hose
Drain trap
" (25 to 38 mm) screw-type clamp
2
Air gap
Large drain
hose clamp
Rubber hose
connector
Drain hose
4. Attach rubber end of drain hose to air
4
gap with a hose clamp. Use a 1" to 1
(25 to 38 mm) screw-type clamp
(not provided).
5. Use a rubber hose (not provided) with
5
screw-type clamps to connect from air
gap to disposer inlet.
Option D: No waste disposer –
with air gap
Screw-type clamps
Waste tee
Drain trap
1 1. Connect rubber end of drain hose
to air gap.
Rubber
end
2 2. Attach drain hose to air gap. Use a
1" to 1
clamp.
3. Use a rubber hose (not provided) with
3
screw-type clamps (not provided) to
connect from waste tee to air gap.
Air gap
Large drain
hose clamp
Rubber hose
connector
Drain hose
/ " (25 to 38 mm) screw-type
1
2
/ "
1
2
19