Ignitor Lighting And Match Lighting The Versaflame; Sideburner Ignitor And Match Lighting - Char-Broil PERFORMANCE Series Use And Care Manual

Match Lighting for Two and Three Burner Grills
s
Do not lean over grill while lighting.
1. Open lid . Turn on gas at LP cylinder.
2. Match holder is on the right rear leg. Attach match to match
holder, light match. Place match into match lighting hole from
outside of grill bottom (as shown).
3. Push in and turn right knob to . Be sure burner lights and
stays lit.
4. Two burner grills, push in and turn left knob to .
Three burner grill, push in and turn center knob to and the
right knob to .
Match Lighting for Three and Four Burner Grills
s
Do not lean over grill while lighting.
1. Open lid. Turn on gas at LP cylinder.
2. Place lit match into match lighting hole from outside of grill
bottom (as shown).
3. Push in and turn right knob to . Be sure burner lights and
stays lit. Push in right-center burner to light, left center and left
burner.
CAUTION
If burner does not light, turn knob(s) to
minutes, try again. If the burner does not ignite with the
valve open, gas will continue to flow out of the burner
and could accidentally ignite with risk of injury.
8
Match holder for two and three
burner grills
Match-lighting hole is
on side of grill bottom
OFF , wait 5
Ignitor Lighting the Versaflame
s
Do not lean over grill while lighting.
1. Open lid. Turn on gas at LP cylinder.
2. Turn LEFT knob to HI.
3. Push IGNITOR Button
Knob (up to 5 times) to light. Be sure burner lights and
stays lit.
4. If burner does not light turn knob(s) to OFF, wait 5 minutes, try
again.
5. Turn CENTER knob to
6. If IGNITOR does not work, follow match lighting instructions.
After Lighting: Turn knob(s) to HI position for warm-up.
Match Lighting the Versaflame
s
Do not lean over grill while lighting.
1. Open lid. Turn on gas at LP cylinder.
2. Attach match to match holder, light match.
3. Place match lighter into large hole on RIGHT side of grill
bottom. Push in and turn RIGHT knob to HI. Be sure burner
lights and stays lit.
4. Turn CENTER knob to HI and then LEFT knob to
Sideburner Ignitor Lighting
1. Turn gas on at LP cylinder.
2. Push in and turn knob to HIGH
3. Turn or push
sure burner lights and stays lit.
4. If burner does not light turn knob(s) to OFF, wait 5 minutes,
try again.
Match Lighting
1. Turn gas on at LP cylinder.
2. Hold lit match to any port on the burner. Push
in and turn sideburner knob to HIGH. Be sure
burner lights and stays lit.
rapidly, or hold, or turn Ignitor
HI to then RIGHT knob to
Match lighting hole on right side
.
(up to 5 times to light burner). Be
HI.
HI.