Panasonic HDC-SD60K Operating Instructions Manual page 46

[QUICK POWER ON]
The unit is put into recording pause approx. 1 second when the power is turned on with the
mode set to or
≥ Depending on the recording conditions, start time may be longer than 1 second in Still
Picture Recording Mode.
≥ In the Quick power on mode, the zoom magnification becomes 1k.
[QUICK START]
This unit is put into recording pause approx. 0.6 seconds after the LCD monitor is reopened.
≥ When in Quick start standby mode about 80% of the power used in Recording pause
mode is being consumed, so the recording time will be reduced.
≥ Start time will not shorten if there is no SD card inserted.
/
Start time will be shortened if the [Built-inMemory] is selected in the [MEDIA SELECT],
even if there is no SD card inserted.
Start time will be shortened if the [HDD] is selected in the [MEDIA SELECT], even if there
is no SD card inserted.
≥ Change the mode to
1 Set
[QUICK START]
2 Close the LCD monitor while the mode is set
to
or
The status indicator A flashes green and the unit goes
into Quick start standby mode.
≥ The lens cover does not close.
3 Open the LCD monitor.
The status indicator A lights red and the unit is put into
recording pause.
≥ Quick start standby mode is canceled if
j about 5 minutes have elapsed
j mode is set to
≥ Depending on the recording conditions, time for Quick Start may be more than 0.6 seconds
slower in Still Picture Recording Mode.
≥ It may take some time for Automatic white balance to adjust.
≥ In the Quick Start Mode, the zoom magnification becomes 1k.
≥ If [ECONOMY] (l 45) is set to [5 MINUTES] and the unit automatically goes into Quick
Start Standby Mode, close the LCD monitor and then open it again.
≥ Turn the unit off using the power button.
46
VQT2M51
[OFF]/[ON]
.
[OFF]/[ON]
or .
to .
[ON]
.