Panasonic HDC-SD60K Operating Instructions Manual page 128

Problem
This unit cannot be
operated though it is
turned on.
This unit does not
operate normally.
Item other than the
touched one is
selected.
The remaining time
indication or the
elapsed time
indication is not
shown.
The unit arbitrarily
stops recording.
Auto focus function
does not work.
128
VQT2M51
≥ Remove the battery or AC adaptor, wait about
1 minute and then reconnect the battery or AC
adaptor. Then about 1 minute later, turn on the power
again. (Conducting the above operation while the
media is being accessed may damage the data on
the media.)
≥ If normal operation is still not restored, detach the
power connected, and contact consumer support.
(l 152, 153)
≥ Calibrate the touch screen. (l 49)
≥ [DISPLAY] of the [SETUP] is [OFF]. (l 44)
≥ Use an SD card that can be used for motion picture
recording. (l 26)
≥ The recordable time may have shortened due to the
deterioration of the data writing speed or repeated
recording and deletion. Using the unit, format the SD
card, built-in memory or HDD. (l 48)
≥ If [AGS] is [ON], record in the normal horizontal
position or set [AGS] to [OFF]. (l 66)
≥
If the unit is exposed to strong vibrations or shocks
while recording on HDD, recording may stop to
protect the HDD. If the unit is used in a place with
loud sounds, the recording may stop due to sound
vibrations. Recording data on an SD card is
recommended in these places.
≥ Switch to Intelligent Auto Mode.
≥ If you are trying to record a scene which is hard to
bring into focus in Auto Focus Mode, use the Manual
Focus Mode to adjust the focus. (l 39, 77)
Check points