Panasonic HDC-SD60K Operating Instructions Manual page 130

Problem
Color or brightness of
the image changes, or
you may see
horizontal bars in the
image.
The LCD monitor
flickers indoors.
Object seems to be
warped.
White round spots like
soap bubbles appear
on the recorded
picture.
"ERROR OCCURRED.
PLEASE TURN UNIT
OFF, THEN TURN ON
AGAIN." is displayed.
130
VQT2M51
≥ Color or brightness of the image may change, or you
may see horizontal bars in the image when the object
is recorded under fluorescent light, mercury light or
sodium light, etc., but this is not a malfunction.
≥ In Motion Picture Recording Mode, record in
Intelligent Auto Mode or set the shutter speed to 1/60
in areas where the power supply frequency is 60 Hz,
or 1/100 in areas of 50 Hz.
≥ In Still Picture Recording Mode, this will not affect the
recorded image.
≥ Object seems to be warped slightly when the object
moves across the image very fast, but this is
because the unit is using MOS for the image sensor.
This is not a malfunction.
≥ If you take a picture with the
flash in a dark place or
indoors, white round spots
may appear on the picture
caused by the flash
reflecting of particles of dust in the air. This is not a
malfunction.
A characteristic of this is that the number of round
spots and their position differ in every picture.
≥ The unit has automatically detected an error. Restart
the unit by turning the power off and on.
≥ The power will be turned off in about 1 minute if the
power is not turned off and on.
≥ Repair is needed if it is repeatedly displayed even if it
is restarted. Detach the power connected, contact
consumer support. (l 152, 153) Do not attempt to
repair the unit by yourself.
Check points