The Radio; Adjust The Volume - Panasonic SC-PM91D Operating Instructions Manual

The radio

SUBWOOFER
H.BASS SOUND
ALL DISC
DISC
GROUP
STOP QUICK REPLAY CM SKIP
QUICK OSD
FUNCTIONS
■ FM frequency step (main unit only)
The step is factory-set to 0.2 MHz, but you can change it to receive
broadcasts allocated to 0.1 MHz steps.
1.Select "FM".
2.Press and hold [TUNER/AUX] on the main unit.
After a few seconds the display changes to show the current
minimum frequency. Continue to hold the button down. The minimum
frequency changes and the step is changed.
To return to the original step, repeat the above steps.
Preset tuning
Preset channels to make selection simpler. You can set up to 15 stations each in the FM and AM bands.
Automatic presetting
Tune to the frequency where presetting is to begin (➡ see above).
Press and hold.
(release when "AUTO" appears)
The tuner presets the stations it can receive into the channels in
ascending order.
When finished, the last station to be set is played.
Manual tuning
1 2
TUNER /
AUX
Select "FM" or Select the
"AM". frequency of the
desired station.
• Press and hold [t] or [y] until the frequency starts scrolling to start automatic tuning. Tuning
stops when a station is found.
"ST" is displayed when a stereo FM broadcast is being received.
If noise is excessive in FM
Press [PLAY MODE] to display "MONO".
To cancel, press [PLAY MODE] again.
The mode also cancels when you change the frequency.
3
Adjust the
volume.
Note
Any preset stations are cleared by this procedure. Preset them
again.
Manual presetting
Tune to the desired station (➡ see above).
1 2
Press to Press while the
select. station is flashing to
select the channel.
("PGM" appears)
The station occupying a channel is erased if another station is preset in
that channel.
Selecting channels
1. Press [TUNER/AUX] to select "FM" or "AM".
2. Press the numbered buttons or [u2/REW] or [i1/FF] to select
the channel.
23