Table of Contents
Advertisement
Use of the speaker cable stickers is
3
convenient when making cable connections.
e.g. Front speaker (L)
A Speaker cable sticker (included)
B Connector
Speaker cable sticker
1 FRONT (L)
2 FRONT (R)
3 SURROUND (L)
4 SURROUND (R)
5 CENTER
6 SUBWOOFER
Be sure to match the number on each sticker with the
connector color.
Speaker assembly option
[BT330] [BT235]
Thread the speaker cable
through the base.
Leave about 120 mm (4
You can remove and use the cable
from the stand. To reattach the
cable, refer to page 40.
[BT730] [BT330] [BT235]
∫ Preventing the speakers from falling
≥Consult a qualified housing contractor concerning the appropriate procedure when attaching to a concrete wall or a surface that
may not have strong enough support. Improper attachment may result in damage to the wall or speakers.
≥Use a string of less than ‰ 2.0 mm (
e.g., [BT730]
FRONT
Lch
Color
WHITE
RED
BLUE
GRAY
GREEN
PURPLE
Attach the speaker.
q)
23
/
32
q), which is capable of supporting over 10 kg (22 lbs).
3
/
32
Connecting the speaker cables. Insert the wire fully,
4
taking care not to insert beyond the wire insulation.
e.g. Surround speaker
≥ Be careful not to cross (short-circuit) or reverse the polarity of the
speaker wires as doing so may damage the speakers.
≥ Don't use a front speaker as a surround speaker or vice versa. Verify
the type of speaker with the label on the rear of the speaker before
connecting the appropriate cable.
≥ To avoid injury by falling or dropping the speaker, place the speaker cables
with care not to stumble or hook.
≥ Do not hold the speaker in one hand to avoid injury by dropping the
speaker when carrying.
Insert the wire fully.
r: White
s: Blue line
Push!
Press into the groove.
Tighten securely.
Slide into the
groove.
A String (not included)
Thread from the wall to the speaker and tie tightly.
B Rear of the speaker
C Screw eye (not included)
D Wall
q)
E Approx.150 mm (5
29
/
32
r: White
s: Blue line
Push!
VQT2M13
11
Hide quick links:
Advertisement
Table of Contents
