Vizio V 2.0 Series User Manual page 13

Remove the battery cover by gently
3
sliding it away from the remote.
Top
When needed, VIZIO recommends replacing the batteries that came with
this remote with two, new Duracell 'AAA' alkaline batteries.
After turning on both your TV and sound bar, it will automatically begin searching for an active input.
The LED indicator on the front of the sound bar will begin cycling in different colors through inputs
5
until an audio source is detected.
Tip: Pressing the INPUT button will stop the auto
detect function.
You can press the INPUT button to switch between audio
sources. For example, if you connected your TV to HDMI
(ARC), set the sound bar to HDMI-ARC.
*Occurs only during first-time set up.
**Auto detect function only occurs once when the sound bar is first powered on. To enable this
feature again, you must do a Factory Reset (see the Using Button Combinations on page 12 for
more information) or press and hold the INPUT button for 4 seconds.
Insert the included batteries and gently
4
slide the battery cover back into place.
Top
**
First-time Setup
Input
*
Power
ENG - 7